Teapot ladle use
The ladle is used for casting in the foundry. After the iron is taken in front of the furnace, it is transported to the mold for pouring.
Teapot ladle main selection method
1 , hanging ladle form, two-way rotary type.
2 , the form of gearbox, double worm gear drive.
3 , speed ratio
4 , the size
Teapot ladle main parameters and prices
This price is for reference only. Contact us will have a very low price, please consult the specific price. firsTfurnace@gmail.com
CB manual, electric teapot ladle technical parameters
Upper port diameter Φ 1 ( mm)
Lower mouth diameter Φ 2 ( mm)
Barrel height H (mm )
Width A (mm )
Height B (mm )
Price ¥ (yuan)
Teapot ladle features
1. Reasonable selection of the center of rotation, easy to operate, basically can be re-created after pouring.
2 , the use of double worm gear drive. Although the manufacturing requirements are high, the transmission is flexible and the two-way reversibility is good.
3. The lifting rod is made of forging, which is safer and safer than steel welded parts.
4 , the body plate is thicker, the bottom structure is triple-insurance combined with taper, bottom hoop and welding, which prolongs the service life and ensures the safety of the operator.
5 , the main body and the boom, the reduction box and the hand wheel are equipped with a chain card to lock at any time.
6 , the two trunnions and the boom are equipped with self-aligning bearings, and the consistency is good.
Use and maintenance of teapot ladles
1. refractory mud, the thickness of which is:
0.5 ton to 3 ton side wall 60 mm bottom 80 mm;
5 tons of side walls 80 mm bottom 100 mm;
10 tons of side wall 100 mm bottom 120 mm;
More than 10 tons of side walls 150 mm bottom mm;
2 , check the hand wheel, should live freely, no jamming phenomenon.
3 , in the two trunnion rolling bearings, add molybdenum disulfide grease once a week.
4. Check if the handwheel locks the card board safely and reliably.
5. Check if there is any oil shortage in the gearbox and check it once a week.
6. After using for a long time, it is found that the gap of the worm gear is increased, and the worm gear pair should be replaced when it is safe to pour.
Copyright© 2007-2013 NO.6 Electric Mall All Rights Reserved